Hi,
On Friday night I came home to find my server which hosts my media machine and my VPN (Virtual Private Network or UK in France), windows XP machine, lying on it's back with it's feet in the air.
After an hour of diagnosis and bodging, I managed to get everything back up and running again.
Today I did a bit of searching for answers and have "repaired" the SSD. I noticed on Friday night that the power had gone off and on again. I know this because my workstation I had been logged into was sitting at the login prompt and put me through the entire first login process. As I only restart the machine every month or two, I know that it restarted.
So with that as a starting point I went looking.
What I found was not very good. I found that SSD's have a problem with unexpected power outages. I suspect it is also to do with how good/stressed your power supply is too. For instance the two SSD in my workstation were OK, but the one in my server was not. My server had 5 x 2TB hard drives in it as well as the SSD.
I found the process to power cycle a SSD and followed it. Without the SATA cable connected, 20 minutes (or so), on then power off for 30 seconds (or so) and power on again. Repeat the process and it's done.
I now have my SSD back.
But the point is this. Before I knew this I pulled the drive from my server and tried it in the USB 3.0 dock beside my workstation. It was not recognised. I have that dock here with me in Belgium and used it to power cycle the drive.
So, anyway, to the point of the article. If you know that you have a SSD and you know you have had a power outage and your drive has mysteriously "vanished", don't suddenly assume you need to buy another one. They are not cheap and they are not dead like a rotating hard drive would be. They are just "stuck" in the middle of a process they can't get out of.
Laptops should be fine as they have a battery and also they do their own clean shut down if the power gets too low.